Intrigue V6-3.8L VIN K (1998)
9.
Select NEW VEHICLE.
10.
Vehicle Identification Number (VIN) will be read. If VIN cannot be read, the VIN will need to be entered manually.
11.
Select SPECIAL.
12.
Select PROGRAM BY VCI.
13.
Enter 1008 for VCI number.
14.
Select DONE.
15.
Summary of selected calibrations is displayed with BCM calibrations. Make sure to select correct calibration based on vehicle features.
16.
Select PROGRAM.
17.
Select YES to confirm programming. Calibration is downloaded to the scan tool.
18.
Connect scan tool to the vehicle DLC.
19.
Select VEHICLE YEAR and TYPE.
20.
After the scan tool displays VIN and end model part number, select PROGRAM soft key to setup/program the BCM.
Theft Deterrent RE-Learn
Perform this procedure when:
^
The BCM has been replaced in the vehicle and the Setup New BCM procedure has been successfully completed.
^
The ignition key cylinder assembly has been replaced.
There are three ways of performing the Theft Deterrent Re-Learn procedure, depending on the type of Techline equipment available:
^
Techline terminal and a Tech 2 scan tool (quickest).
^
T-50 or T-60.
^
Re-Learn without a scan tool or Techline equipment (slowest).
Theft Deterrent RE-Learn Using Techline Equip./Tech 2 Scan Tool
1.
Connect scan tool to the Data Link Connector (DLC) on the vehicle.
2.
At the scan tool main menu, select SERVICE PROGRAMMING.
3.
Enter the requested vehicle information, then select REQUEST INFO.
4.
Disconnect the scan tool from the vehicle.
5.
Connect the scan tool to the Techline terminal.
6.
Select SERVICE PROGRAMMING SYSTEM (SPS).
7.
Select TERMINAL TO TECH 2 PROGRAMMING.
8.
Select DONE and follow instructions on the Tech line terminal to Handheld Communications Setup screen.
9.
Select THEFT MODULE RE-LEARN.
10.
At the summary screen, select PROGRAM. The terminal will then download information to the scan tool.
11.
Disconnect the scan tool from the Techline terminal.
12.
Connect the scan tool to the DLC on the vehicle.
13.
At the scan tool main menu, select SERVICE PROGRAMMING.
