Intrigue V6-3.8L VIN K (1998)
Knock Sensor: Description and Operation
Knock Sensors
The knock sensors detect abnormal vibration (spark knocking) in the engine. The sensors are mounted in the engine block near the cylinders. The knock
sensors produce an AC voltage signal under all engine operating conditions. The PCM adjusts the Ignition Control (IC) spark timing based on the
amplitude and frequency of the KS signal being received.
The PCM contains integrated Knock Sensor (KS) diagnostic circuitry. The PCM uses the circuitry to diagnose the KS sensors and related wiring. The
PCM calculates an average voltage of each knock sensor's signal and performs instantaneous signal voltage readings. The PCM uses the instantaneous
signal voltage readings to determine the state of the knock sensor circuitry. If the knock sensor system is operating normally, the PCM should monitor
instantaneous KS signal voltage readings varying outside a voltage range above and below the calculated average voltage. If the PCM malfunctions in a
manner which will not allow proper diagnosis of the KS circuits, DTC P0325 will set. DTCs P0327 and P0332 are designed to diagnose the knock
sensors, and related wiring. Problems encountered with the KS system should set a DTC.
