Intrigue V6-3.8L VIN K (1998)
Air Bag Control Module: Service and Repair
Removal Procedure
1. Disable the SIR system. Refer to Disabling the SIR System. See: Air Bag(s) Arming and Disarming/Service and Repair/Air Bag Disarming and
Arming/Disabling the SIR System
2. Remove the passenger front seat. Refer to Seat Replacement - Front Bucket in Seats. See: Seat Belt Systems/Seat Belt Buckle/Service and Repair
3. Remove the passenger front carpet retainers, then roll back the carpet. Refer to Carpet Retainer Replacement in Interior Trim.
4. Remove the Connector Position Assurance (CPA) from the inflatable restraint Sensing and Diagnostic Module (SDM) harness connector.
5. Disconnect the SDM harness connector from the SDM.
6. Remove the SDM mounting fasteners (1).
7. Remove the SDM (2) from the floor pan (3).
Important: If the SDM mounting holes or fasteners are damaged to the extent that the module can no longer be properly mounted, use the following
repair. Torque the replacement fastener with a hand tool in order to prevent stripping the replacement fastener.
