Intrigue V6-3.8L VIN K (1998)
Brake Light Switch: Adjustments
NOTICE: Proper stoplamp switch adjustment is essential. Improper stoplamp switch adjustment may cause brake drag, heat buildup and excessive
brake lining wear.
IMPORTANT: Adjust the stoplamp switch and the cruise control switch at the same time. The adjustment procedures for both switches are identical.
With the brake pedal in the fully released position, ensure that the stoplamp plunger is fully depressed against the brake pedal shanks.
1. Insert the stoplamp switch and the cruise control switch (if equipped) into the brake pedal bracket.
2. Push and hold the brake pedal forward in order to set the brake push rod into the booster.
3. Push the stoplamp switch and the cruise control switch all the way into the brake pedal bracket until the switch housings contact the bracket.
4. Pull the brake pedal to the rear, against the internal stop. This adjusts both the stoplamp switch and the cruise control switch.
5. Inspect the stoplamp switch for proper adjustment. For diagnosis of the stoplamps, refer to Stop Lamps Inoperative - All (Stop Lamps) or Stop
Lamps Always On in Lighting Systems.
