Intrigue V6-3.8L VIN K (1998)
Combination Switch: Service and Repair
Turn Signal and Multifunction Switch
DISASSEMBLY PROCEDURE
1. Remove the upper and lower shrouds. Refer to STEERING COLUMN SHROUDS.
2. Remove 1 wire harness strap (2) from the wire harness assembly. Remove 1 wire harness strap (2) from the upper tilt head assembly (1).
3. Pop the wire harness assembly (1) from the wire harness strap (2).
4. Remove the 2 tapping screws (1).
5. Remove the turn signal and multifunction switch assembly (2).
ASSEMBLY PROCEDURE
NOTICE: Always use the correct fastener in the proper location. When you replace a fastener, use ONLY the exact part number for that application.
