Intrigue V6-3.8L VIN K (1998)
The manufacturer will call out those fasteners that require a replacement after removal. The manufacturer will also call out the fasteners that require
thread lockers or thread sealant. UNLESS OTHERWISE SPECIFIED, do not use supplemental coatings (paints, greases, or other corrosion inhibitors)
on threaded fasteners or fastener joint interfaces. Generally, such coatings adversely affect the fastener torque and joint clamping force, and may
damage the fastener. When you install fasteners, use the correct tightening sequence and specifications. Following these instructions can help you
avoid damage to parts and systems.
1. Install the turn signal and multifunction switch assembly (2) and secure by using 2 pan head tapping screws (1).
Tighten
Tighten the screws to 7 Nm (62 inch lbs.).
2. Route the wire harness assembly (1) along the steering column jacket assembly.
3. Pop the wire harness assembly (1) into the wire harness strap (2).
4. Install 1 wire harness strap (2) to the upper tilt head assembly (1). Install 1 wire harness strap (2) onto the wire harness assembly.
5. Install the upper and lower shrouds. Refer to STEERING COLUMN SHROUDS.
