Intrigue V6-3.8L VIN K (1998)
7. Disconnect the fuel tank pressure sensor (7) electrical connector.
8. Clean the fuel pipes, and fuel sender assembly to prevent possible fuel contamination during removal.
9. Disconnect the quick-connect fittings at the fuel sender assembly. Refer to Fuel Line Coupler Service (Metal Collar).
10. Remove the fuel sender retaining snap ring.
11. Remove the modular fuel sender assembly.
12. Clean the fuel sender assembly O-ring sealing surfaces.
13. Inspect the fuel sender assembly O-ring sealing surfaces.
Installation Procedure
Notice: Always re-attach the fuel lines and fuel filter with all original type fasteners and hardware. Do not repair sections of fuel pipes.
Important: Care should be taken not to fold over or twist the fuel pump strainer when installing the fuel sender assembly, as this will restrict fuel flow.
Also, assure that the fuel pump strainer does not block full travel of float arm.
Important: Be sure that the fuel sender assembly retaining snap ring is fully seated within the tab slots on the fuel tank.
1. Position the new fuel sender assembly O-ring on the fuel tank.
2. Reinstall the fuel sender assembly into the fuel tank.
3. Reinstall the fuel sender assembly retaining snap ring.
