Intrigue V6-3.8L VIN K (1998)
Wiper Motor Replacement: Removal Procedure
5. Remove the wiper motor crank arm assembly from the wiper motor assembly.
5.1. Remove the rubber boot from the wiper motor crank arm assembly.
5.2. Loosen the screw.
5.3. Tap on the screw with a soft-faced mallet while holding up on the wiper motor crank arm assembly until the wiper motor crank arm
assembly is loose on wiper motor assembly.
5.4. Remove the screw and wiper motor crank arm assembly from wiper motor assembly.
Wiper Motor Replacement: Removal Procedure
6. Remove three screws and wiper motor assembly from wiper drive system module.
7. Remove the shaft seal and the water shield from the wiper motor assembly.
INSTALLATION PROCEDURE
Tools Required
J 39529 Wiper Transmission Installer
