LSS V6-3.8L VIN K (1997)
Shaft Key, Clutch Plate/Hub Installation
Installing Clutch Plate & Hub Assembly
Remove or Disconnect
1. Clamp the holding fixture J 34992 in a vise and attach compressor to holding fixture with thumb screws J 34992-1.
2. Keep the clutch hub and drive plate assembly from turning by using the clutch hub holding tool J 33027-A. Remove the shaft nut using shaft nut
socket J 33022.
3. Thread the Clutch Plate and Hub Assembly Remover J 33013-B into the hub. Hold the body of the remover with a wrench and turn the center
screw into the remover body to remove the clutch plate and hub assembly.
4. Remove the shaft key and retain for reassembly.
Install or Connect
1. Install the shaft key into the hub key groove. Allow the key to project approximately 3.2 mm (1/8") out of the keyway. The shaft key is curved
