LSS V6-3.8L VIN K (1997)
Powertrain Control Module: Service and Repair
EEPROM Programming
SET-UP
1. Ensure that the following conditions have been met:
^
The battery is fully charged.
^
The ignition is ON.
^
The cable connection at the DLC is secure.
2. Program the PCM using the latest software matching the vehicle.
-
Refer to up-to-date Techline equipment users instructions.
3. If the PCM fails to program, proceed as follows:
^
Ensure that all PCM connections are OK.
^
Check the Techline equipment for the latest software version.
^
Attempt to program the PCM. If the PCM still cannot be programmed properly, replace the PCM. You must program the replacement PCM.
^
Perform the crankshaft position system variation learn procedure.
-
Refer to Crankcase Position System Variation Learn Procedure.
FUNCTIONAL CHECK
1. Perform the On-Board Diagnostic System Check.
2. Start the engine and the engine run for one minute.
3. Use the scan tool in order to scan for the DTCs.
4. If DTC P0325 sets, the KS module is not fully seated, is missing, or is malfunctioning.
5. If DTC P1336 sets, perform the crankshaft position system variation procedure.
