LSS V6-3.8L VIN K (1997)
Fuel Tank Unit: Service and Repair
Fuel Sender Assembly Service
Description
Description
Fuel Pump
REMOVAL PROCEDURE
1. Relieve the fuel system fuel pressure.
2. Drain the fuel tank.
3. Remove the fuel tank.
4. Remove the fuel sender assembly.
DISASSEMBLE PROCEDURE
1. Inspect the position of the fuel pump fuel strainer (3) for installation.
2. Support the fuel pump (4) with one hand and grasp the fuel pump fuel strainer with the other hand
3. Pull the fuel pump fuel strainer off of the fuel pump.
4. Inspect the fuel pump fuel strainer. If the fuel pump fuel strainer is contaminated, the fuel tank should be cleaned.
5. Discard the fuel pump fuel strainer after inspection.
6. Inspect the fuel pump inlet for dirt and debris. If dirt and debris are found, the fuel pump should be replaced.
