LSS V6-3.8L VIN K (1997)
IMPORTANT: Do Not apply thread sealant to sensor threads. The sensor is coated at factory and applying additional sealant will affect the
sensors ability to detect detonation.
1. Install the knock sensor into the engine block.
-
Tighten Knock sensor to 19 Nm (14 lb ft).
2. Install the knock sensor heat shield mounting bolt located under the freeze plug (or block heater if equipped).
3. Connect the knock sensor wiring harness connector to the knock sensor.
4. Install the splash shield.
5. Lower the vehicle.
6. Fill the cooling system.
7. Connect the negative battery cable.
