LSS V6-3.8L VIN K (1997)
INSTALL OR CONNECT
1. Flow control spring (12).
2. Control valve assembly (13).
3. Lubricate new O-ring (15) with power steering fluid.
^
O-ring (15) on fitting (16).
4. Fitting (16) into hydraulic pump housing assembly (10).
^
Tighten fitting (16) to 75 Nm (55 ft. lbs.).
5. Pump assembly to vehicle, if removed.
Drive Shaft Seal (Without Disassembly of Pump)
^
Tool Required:
-
J 7728 Shaft Oil Seal Installer
-
Or Equivalent
REMOVE OR DISCONNECT
1. Pump assembly from vehicle, if necessary for access.
2. Protect drive shaft (7) with shim stock.
3. Seal (11) and discard. (Use small chisel to cut drive shaft seal.)
INSTALL OR CONNECT
1. New drive shaft seal (11), lubricated with power steering fluid, using tool J 7728.
2. Pump assembly to vehicle, if removed.
Hydraulic Pump Assembly
