Ninety-Eight V6-252 4.1L VIN 4 4-BBL (1982)
FIGURE 2
9.
Using funnel J-34155-3, pour the sifted beads into the lower bed of the new converter. (See Figure 2.) Tap belt flange with rubber mallet
to allow beads to settle. Continue filling and tapping until converter is full. If additional beads are required to completely fill the lower
bed, it will be necessary to obtain a lower bed bead kit from the parts department.
Excess beads from the kit should be saved in a clean container for future use.
10.
Lay the converter down on a flat surface with the lower bed fill hole on top.
11.
Insert the fill plug into the lower bed fill hole. The fill plug outer rim must rest against the converter body.
FIGURE 3
12.
Insert tool J-34188 into fill plug and tighten to a torque of 47 N-m (35 ft.lbs.). (See Figure 3.)
13.
Install new converter in vehicle reversing removal procedure (Steps 1, 2, and 3) and using new bolts and clamp as required. Tighten
front clamp nuts to 35 N-m (26 ft.lbs.), intermediate pipe to converter bolts to 20 N-m (15 ft.lbs.) and hanger to converter bolts to 52
N-m (38 ft.lbs.).
14.
Lower vehicle and install campaign identification label, Part C of procedure.
C.
Campaign Identification Label
Each vehicle modified in accordance with the instructions outlined herein will require a Campaign Identification Label. Each label
provides a space to include the campaign number, the five (5) digit dealer code of the dealer performing the campaign service, and the
date vehicle was campaigned. This information may be inserted with a typewriter or ballpoint pen. When installing label, clean the
surface of the fan shroud and apply the campaign label.
Parts Information
Parts are to be obtained from GMWDD using the following part numbers:
Description
Part No.
