Ninety-Eight V6-3.8L VIN K (1995)
Accelerator Pedal: Service and Repair
Accelerator Pedal Assembly
ACCELERATOR PEDAL REPLACEMENT
When performing service on the accelerator pedal, observe the following:
^
The mounting surface between support and dash panel must be free of insulation. The carpet and padding in pedal and tunnel area must be
positioned to lay flat and be free of insulation. The carpet and padding in pedal and tunnel area must be positioned to lay flat and be free of
wrinkles and bunches.
^
Slip accelerator control cable through slot in rod and then install retainer in rod, being sure it is seated. Care must be utilized in pressing the
retainer into hole in rod, to assure the cable is not kinked or damaged in any way.
^
After securing all components of the accelerator linkage, linkage must operate freely, without binding, between full closed throttle and full wide
open throttle.
^
Wire, hoses, cables or other obstructions must not be placed within 13 mm (33/64 inch) of cable or rod at any point in their travel.
