Ninety-Eight V6-3.8L VIN K (1995)
3.
Reposition carpet around lamp control module (see figure 1).
4.
Remove lamp control module from mounting bracket.
5.
Disconnect connectors (2) from Lamp Control Module.
6.
Install connectors to new lamp control module and install module into mounting brackets.
7.
Reinstall carpet and right sound insulator panel.
8.
Reconnect negative battery cable. If memory retention device was not used, please reset (to the extent possible) all devices that lost their memory
after the battery was disconnected.
9.
Check for proper operation of exterior lamps.
10.
Install campaign identification label.
Campaign ID Label
Each label provides space to print the campaign number and the five (5) digit retailer code of the retailer performing the campaign. Insert this
information with a typewriter or ball-point pen. When installing label, clean and dry the surface of the radiator support tie bar and apply the campaign
label where it is readily visible.
Each campaign identification label is to be located on the radiator core support in an area which will be visible when the vehicle is brought in for
periodic servicing bt the owner.
Warranty Claim Information
Submit claims using the "V" labor operation for each vehicle as shown.