Ninety-Eight V6-3800 3.8L (1989)
^
Order only as many weatherstrip seal kits as you anticipate using over the next thirty days.
^
Upon receipt of the weatherstrip seal kh from GMSPO, open the package and inspect the date code located on the back label of the Loctite Black
Max 380 Adhesive bottle as shown in Figure 5. If the date code is greater than 12 months prior to the current date, return the weatherstrip seal kit
to GMSPO utilizing procedures for defective material described in the GMSPO Parts Policy and Procedures Manual.
^
If weatherstrip seal kits have been received which will not be used within the upcoming thirty days, the Locthe Black Max 380 Adhesive should be
removed from the kit and refrigerated until use occurs.
^
If the weatherstrip seal kit is not used upon receipt at the dealership, and the adhesive was in-date at the time of receipt, it is the dealer's
responsibility to ensure that the adhesive has not expired before use.
^
If adhesive is left over after completion of the weatherstrip seal kit installation procedure, it should be refrigerated if it is intended to be used at a
later date. In any case, Loctite Black Max 380 Adhesive should be discarded if the date code on the back label of the bottle is greater than 12
months prior to the current date. Refer to Figure 5 for interpretation of the date code information.
INSTALLATION PROCEDURE:
1 .
Remove sunroof sliding glass panel as described in the Roof Section of the appropriate service manual.
2.
Place glass panel upside down on a padded workbench, being careful not to scratch the glass surface.
3.
Remove the old weatherstrip seal by peeling the seal off of the glass panel molding, starting at the butt joint.
4.
Using a clean shop rag, remove any loose adhesive material from the weatherstrip seal mounting surface on the glass panel molding.
