Ninety-Eight V6-3800 3.8L (1989)
REMOVE OR DISCONNECT
1. Regulator.
2. Motor by drilling out rivets holding motor to regulator using a 4.8 mm (3/16") drill bit.
INSTALL OR CONNECT
1. Motor to regulator using 3/16" rivets.
2. Regulator.
Window Regulator Tape
REGULATOR TAPE
REMOVE OR DISCONNECT
1. Regulator.
2. Connect regulator motor to harness connector.
3. Tape from tabs on regulator.
4. Run tape out of regulator.
INSTALL OR CONNECT
1. Cut service tape to 705 mm (27 3/4").
2. Tape to regulator.
3. Slots on tape to tabs on regulator.
4. Regulator.