Ninety-Eight V6-3800 3.8L (1989)
Figure 5
15.
Except where push-in molding will be inserted, paddle excess urethane around glass to ensure water-tight seal. If necessary, paddle additional
material to fill voids in seal, Figure 5.
16.
Remove protective coverings from body.
17.
Install "push-in" type reveal moldings.
18.
If reveal moldings won't stay in proper position, use cloth waterproof tape to hold them in position until adhesive is cured.
19.
Water test car using a soft spray. Use warm or hot water if available. Do not direct hard stream of water at fresh adhesive material. If any leaks are
found, paddle in extra adhesive at leak point using a small disposable brush or flat-bladed tool. Water applied on top of urethane adhesive will
speed up the cure of the urethane.
20.
Install remaining reveal moldings and wiper arms.
21.
Vehicle must be kept at a minimum of 65~ F for six hours to allow material to cure.
22.
Remove tape.
WARRANTY INFORMATION
Labor Operation Number:
C0034
