Ninety-Eight V6-3800 3.8L Supercharged (1993)
2.
Install new upper transaxle oil cooler hose assembly to transaxle finger tight.
3.
Tighten fitting at transaxle to 27 NM (20 lb. ft.).
4.
Push hose onto cooler tube (at radiator) until hose end touches tube stop bead.
5.
Install new whose clamp P.N. 25621969 on hose at pipe end. Tighten clamp to 4.0 NM + 0.5 NM (35 lb. in. + 4 lb. in.)
6.
Insure pipe is located properly in transaxle support bracket slot and designed retainers.
7.
Check and refill transaxle as necessary. Use only Dexron III Automatic Transmission Fluid. Start vehicle and check for fluid leaks.
8.
Install a Campaign Identification Label.
Vehicles With (1) Piece Upper Trans. Oil Cooler Line Assem.
VEHICLES WITH A ONE (1) PIECE UPPER TRANSAXLE OIL COOLER LINE ASSEMBLY
NOTICE
A SMALL QUANTITY OF 1992 AND 1993 EIGHTY EIGHT AND NINETY EIGHT VEHICLES WERE BUILT WITH ONE PIECE
TRANSAXLE OIL COOLER LINES (WITH NO HOSE CLAMP). ON THESE VEHICLES IT WILL BE NECESSARY TO REPLACE THE
COMPLETE LINE WITH A NEW PART NUMBER P.N. 25623916
1.
Remove old one piece upper transaxle oil cooler hose assembly.
2.
Install new one piece upper transaxle oil cooler hose assembly to transaxle and radiator finger tight.
3.
Tighten fitting at transaxle to 27 NM (20 lb. ft.).
4.
Tighten fitting at radiator to 27 NM (20 lb. ft.).
5.
Insure pipe is located properly in transaxle support bracket slot and designed retainers.
6.
Check and refill transaxle as necessary. Use only Dexron III Automatic Transmission Fluid. Start vehicle and check for fluid leaks.
7.
Install a Campaign Identification Label.
Campaign ID Label
Each label provides a space to include the subject corporate campaign number and the Oldsmobile retailer identification (dealer) code of the retailer
completing the campaign service. This information must be inserted with a ball point pen. Servicing retailers are to ensure that these numbers are
recorded and the label is properly affixed on a clean, dry surface of the radiator core support in an area clearly visible when the hood is raised. This label
is to be used in conjunction with a clear protective plastic cover which will also be provided to retailers when labels are ordered. Additional labels and
covers are available at no charge to you in sheet stock of forty nine (49) per sheet from the following source:
VISPAC, INCORPORATED
35000 INDUSTRIAL ROAD
LIVONIA, MICHIGAN 48150
PHONE: 1-800-269-5100 ( Monday - Friday 8:00 AM to 4:30 PM Eastern Standard Time)
IMPORTANT:
Refer to Item Number S-1015 when ordering GM Campaign Identification Label
Each retailer will be shipped a special tool, J-41487 (spring hose clamp pliers), form Kent Moore, the week of March 25, 1996. The tool is furnished at
no charge to the retailer. Additional tools, if required, may be ordered from Kent-Moore and will be charged to the retailer's open account. Fleet
Warranty Stations may obtain information on how to purchase tools from Kent-Moore by calling 1-800-345-2233 and asking for the "order desk".
Warranty Claim Information
NOTE:
THE ONE TENTH HOUR (0.1 HR) ADMINISTRATION ALLOWANCE IS NOW INCLUDED IN THE LABOR HOURS TIME.
