Ninety-Eight FWD V6-181 3.0L (1985)
FIGURE 1
6.
Apply one or two coats of adhesion promoter within moldings and/or breaklines of the panel section(s) to be refinished. When making paint
repairs to areas such as quarter panels where the repair is not confined within moldings or breaklines, apply adhesion promoter a minimum of 4" -
6" onto adjacent panel. Adhesion promoter must extend beyond the area to be covered by the clearcoat when not confined by moldings (Figure 1).
Allow to flash a minimum of 30 minutes before applying base color coat. Some enamel basecoat may not require adhesion promoter. Follow
manufacturer's recommendations.
7A. Polyurethane Enamel Basecoat
CAUTION: There are a number of paint systems available for service use; however, many require additives containing isocyanates. It is essential that
all recommendations and warnings listed on the container label for materials selected be followed.
It is mandatory that adequate respiratory protection be worn. Examples of such protection are: 3-M models No. 6984 and No. 6986 disposable
