Ninety-Eight FWD V6-181 3.0L (1985)
FRONT DOOR SCALP MOLDING WITH AUXILIARY WINDNOISE CLOSEOUT SEAL
SERVICE INSTALLATION INSTRUCTIONS
1.
Apply soap solution to cover complete perimeter of outer edge of stationary door frame. Completely cover black scalp molding clip at lower front
edge of door frame. (Figure 1)
2.
Slide front door window frame scalp molding assembly three quarters of the way down over the black scalp molding clip at the lower front of the
door. (Figure 1)
3 & 4. Position front door window frame scalp molding assembly to front door. Starting at the upper rear corner, engage over outer edges of the top leg
and upper rear vertical leg of the door frame simultaneously. (Figure 3) Once corner on frame, push scalp molding as far forward as possible on
horizontal leg of header.
5 - 11. Engage molding over the outer edge of the stationary door frame and snap molding onto retainer clips on the inner edge of stationary door frame
(Figure 2) working in the order depicted in Figure 3.
IMPORTANT:
Cross section of correctly installed molding (Figure 4). Installation Tool # J 38714 available through Kent-Moore.
