Ninety-Eight FWD V6-181 3.0L (1985)
7.
To remove the Trip Odometer, the Fuel Gauge must be removed first.
8.
If a condition is found with the Speedometer, the Speedometer assembly must be sent to an authorized AC-Delco Service Center. The
Speedometer assembly consists of the Speedometer pointer, air core gauge mechanism, and circuit board.
9.
If a condition is found with the FUEL, VOLTS, OIL, or TEMP gauge, the pointer and air core gauge mechanism must be replaced as one unit.
FIGURE 4
10.
If a condition with the Odometer(s) is diagnosed to the circuit board, the stepper motor must be replaced. See Item No. 8 in Figure 4.
11.
To remove a stepper motor, first take out the screws holding the odometer module in place and then remove the Odometer.
12.
To remove the printed circuit on the back of the cluster, remove all bulbs, then remove the metal clips from the inside of the cluster. The printed
circuit is now able to be removed.
