Ninety-Eight FWD V6-181 3.0L (1985)
4.
Align valve notch in wire wheel cover with valve stem on wheel. Place cover on wheel by hand only. DO NOT USE A HAMMER TO INSTALL
COVER.
5.
Tighten lock nut or bolt by turning lock key wrench clockwise. This will secure the wire wheel cover.
FIGURE 2
6.
On Ninety-Eight models, move the anti-rotation latch over until it contacts lock nut. See Figure 2.
7.
Snap in center medallion.
FIGURE 3
8.
Install the Wire Wheel Cover Removal Instruction label to underside of deck lid next to jacking instruction label. See Figure 3.
9.
The lock key wrench is to be placed in the glove box along with the I.D./Registration Card.
The procedure for removal and installation is to be explained to the owner prior to delivery.
