Ninety-Eight FWD V6-181 3.0L (1985)
Throttle Position Sensor: Adjustments
Verify that minimum idle is at specified value.
Make all checks/adjustments with engine at operating temperature.
Carbureted Models: Remove aluminum plug covering the adjustment screw. Remove the screw and connect a digital voltmeter from the TPS black
wire (-) and either of the other two colored wires (+). If voltage is approximately 5 volts, this is the reference voltage source. Connect DVOM to the
other wire in this case. Apply thread locking compound to the screw and with ignition on and engine not running (as applies), quickly adjust screw to
obtain specified voltage at indicated condition.
Fuel Injected Models: Disconnect harness connector from TPS. Using three six-inch jumper wires, reconnect harness to TPS. With ignition on and
engine not running (as applies), connect a digital voltmeter to black wire (-) and either of the other two colored wires (+). If voltage is approximately 5
volts, this is the reference voltage lead. Connect DVOM to the other wire in this case. Check reading against specified value. If TPS is adjustable, loosen
the unit retaining screws and rotate the unit to reach specified value.
