Ninety-Eight FWD V6-181 3.0L (1985)
FIGURE 1
Service Action:
All 1986 model THM 440-T4 transaxles were built without an input shaft to 4th clutch shaft seal. When servicing a THM 440-T4 built prior to 1986, it
is not necessary to replace the input shaft to 4th clutch shaft seal. Refer to Figure 1 for transaxle identification information.
Service Manual Reference:
Refer to page 440-T4-32, Figure 34, item 627,1984 service manual.
III. CONVERTER CLUTCH REGULATOR VALVE SPRING ELIMINATED
FIGURE 1
FIGURE 2
Service Action:
At the start of 1986 production, the converter clutch regulator valve spring (refer to Figure 2, Item No. 394) was eliminated on the following models of
the THM 440-T4 transaxle: AAH, ACH, ADH, AFH, AMH, ARH, BHH, CFH, CHH, CMH, CNH, HBH and HJH, due to recalibration and fluid
passage changes. Do not replace this spring on any listed model, as an increase of the apply feel of the transaxle converter clutch may result. Refer to
Figure 1 for transaxle identification information.
Service Manual Reference:
