oldsmobile Workshop Repair Guides

Oldsmobile Workshop Service and Repair Manuals

All Technical Service Bulletins: > < A/T - New Oil Pressure Also Vacuum Related Shift Concern
Page 2
background image

The updated oil pressure chart in the illustration replaces the oil pressure chart in the 1984 Cutlass Ciera, Omega and Firenza Chassis Service Manual.

PRELIMINARY CHECK PROCEDURE

CHECK TRANSMISSION OIL LEVEL CHECK AND ADJUST T.V. CABLE
CHECK OUTSIDE MANUAL LINKAGE AND CORRECT CHECK ENGINE TUNE INSTALL OIL PRESSURE GAUGE* CONNECT
TACHOMETER TO ENGINE

CHECK OIL PRESSURES IN THE FOLLOWING MANNER:
Minimum Line Pressure Check With the brakes applied, take the line pressure readings in the ranges and at the engine r.p.m.'s indicated in the chart
below.

Full Line Pressure Check Full line pressure readings are obtained by removing the vacuum line from modulator, and with the brakes applied, take the
line pressure readings in the ranges and at the engine r.p.m.'s indicated in the chart below.

NOTICE

Total running time not to exceed 2 minutes.

CAUTION

Brakes must be applied at all times.

Line pressure is basically controlled by pump output and the pressure regulator valve. In addition, line pressure is boosted in Reverse, and Lo by the
reverse boost valve.

Also, in the Neutral, Drive and Reverse positions of the selector lever, the line pressure should increase with throttle opening because of the vacuum
modulator.

All Technical Service Bulletins: > < A/T - New Oil Pressure Also Vacuum Related Shift Concern