Ninety-Eight FWD V6-181 3.0L (1985)
Figure 3
c.
Apply black glass prep No. 2 primer directly over clear primer area.
IMPORTANT:
Two kits will be required per vehicle.
10.
On Eighty-Eight and Ninety-Eight apply insulation strip, part number 25540623, along lower inboard edge of glass so as to allow 12-15 mm of
glass clearance from edge of glass to bottom edge of insulation strip. Refer to Figure 3.
On Toronado apply insulation strip, P/N 20375201, along lower inboard edge of glass so as to allow 32-34 mm of glass clearance from edge of
glass to bottom edge of insulation strip. Refer to Figure 3.
Parts are currently available from GMSPO.
Figure 4
11.
Trim urethane dispense tip as shown in Figure 4, View A.
12.
Apply urethane bead to glass ensuring a bead size of 7 mm wide by 8-10 mm high.
13.
Position glass in opening onto spacers. With glass centered in opening, place glass on lower supports and use tape applied in step 8 to carefully
place glass in proper position.
14.
Press glass firmly to set adhesive. Use care to avoid excessive squeeze out which may cause an appearance problem.