Ninety-Eight FWD V6-181 3.0L (1985)
FIGURE 6
13.
Position glass in opening onto spacers aligning masking taps on glass and roof, then lightly press glass in place to wet urethane to opening.
14.
Except where push-in molding will be inserted, paddle excess urethane around glass. Do not undercut bead (see Figure 6).
15.
If necessary, add additional urethane between glass and body to fill any voids.
16.
Remove protective coverings from body.
17.
Install "push-in" type reveal moldings (if used).
18.
If reveal moldings won't stay in proper position at upper corners, use cloth waterproof tape, to hold them in position until adhesive is cured.