Ninety-Eight FWD V6-181 3.0L (1985)
1.
Remove cover harness connector. (See Illustration.)
2.
Apply 12V(+) to No. 6 terminal.
3.
Pump should run and fluid should spray on windshield.
4.
If washer pump does not run, replacement is required; go to step 11.
ITEMS NOT COVERED BY SPECIAL POLICY, STEPS 5 THROUGH 9
5.
If washer pump runs but fluid does not spray on windshield, follow steps below.
6.
Remove washer bottle cap and examine filter screen at bottom of hose. Clean if necessary; add washer fluid as required.
If gummy residue is found on filter screen, empty washer bottle, clean filter screen and bottle, and refill with approved GM washer fluid.