Omega L4-151 2.5L VIN 5 2-bbl (1982)
FIGURE 1
3.
Position three (3) gauges; J-26935-2 on input bearing, J-26935-4 onto output bearing and J-26935-3 on the differential bearing. Be sure the
bearing races fit smoothly into the bores of the gauge tools. See Figure 1.
4.
On J-26935-4 (output shaft), install metal oil shield retainer into bore on top of tool.
FIGURE 2
5.
Carefully assembly the clutch cover over the three (3) gauges and onto the case, using seven (7) spacers placed evenly around the perimeter.
Retain with bolts provided. See Figure 2.
Draw the cover to the case by tightening alternately and gradually. Tighten bolts to 13 N-m (10 ft.lbs.). This will compress all three (3) gauge
sleeves.
6.
Rotate each gauge to seat the bearings. Rotate the differential case through three
(3)
revolutions in each direction.
