Silhouette V6-191 3.1L (1990)
PROCEDURE:
1.
Remove speaker covers to access trim panel retaining screws and remove.
2.
Remove the rest of retaining screws and remove trim panel.
3.
Remove rear pillar shoulder belt anchor bolts.
4.
Remove rear pillar trim.
5.
Support lift gate in full open position with a padded jack stand to prevent damage.
6.
Remove struts from the door and body and discard.
7.
Remove the stud from the lift gate. With the stud removed, place it upside down in a one inch deep well socket and drive the washer off the stud.
Discard washer and save stud for later use.
8.
Using bolts supplied in kit, attach brackets to the door, finger tight or snug.
9.
Drill a 13/64" rivet hole in the door as shown in Figure 2. Install rivets supplied from kit.
