Silhouette V6-191 3.1L (1990)
Weatherstrip: Customer Interest
Front Doors - Wavy Outer Belt Seal Strips
SUBJECT
WAVY OR PUCKERED OUTER BELT SEAL STRIPS ON
FRONT DOORS (SERVICE PROCEDURE)
MODELS/YEARS
1990 SILHOUETTE
NUMBER:
90-T-113
CORP.REF.NO: 931050
DATE:
May 1990
SECTION:
10
Some early model 1990 Silhouettes may exhibit wavy or puckered outer belt sealing strips on the front doors. This condition may be noticed in the
curved section of the seal strip.
This condition may be addressed by using the following procedure and it will not be necessary to replace the outer belt seal strips.
Procedure:
1.
Raise the door glass to full up position.
2.
Using a heat gun, carefully heat the outside surface of the seal strip.
NOTICE:
BE CAREFUL NOT TO HOLD THE HEAT GUN TOO CLOSE TO THE PANEL, AS PAINT DAMAGE COULD OCCUR.
3.
Using a cloth to protect finger tips, carefully press the wavy or puckered area to better conform to the glass surface.
WARRANTY INFORMATION:
Labor Operation:
T1537 (One or Both Sides)
Labor Time:
0.2 Hour (Both Sides)
Trouble Code:
92
