oldsmobile Workshop Repair Guides

Oldsmobile Workshop Service and Repair Manuals

Front Heater Core|Page 2338 > < Front Heater Core|Page 2336
Page 8
background image

REMOVE OR DISCONNECT

1. Drain engine coolant.
2. Two screws (1027) attaching RH windshield wiper transmission (1026) arm to windshield wiper frame (1025).
3. Move windshield wiper transmission (1026) arm aside to gain access to heater hoses.
4. Clamp and heater outlet hose (1076 or 1072) from heater core (1097).
5. Clamp and heater inlet hose (1053 or 1068) from heater core (1097).
6. RH I/P sound insulator panel pushin retainers (155), screw (159) and nut (158) from stud.
7. Carefully pull RH H) sound insulator panel (155) away from I/P
8. Floor (courtesy) lamp (157) from RH H) sound insulator panel (155).
9. RH I/P sound insulator panel (155) from vehicle.

10. Open I/P compartment door.
11. Three screws (1016) from bottom of I/P compartment insert (1015).
12. Three upper I/P compartment screws (1016) with two bumpers (1017).
13. I/P wiring harness connector from I/P compartment lamp and switch assembly.
14. I/P compartment (with door) (1015) from I/P.
15. Two screws (1085) retaining I/P lower extension housing (139) to I/P lower extension support bracket (1086).
16. RH I/P outer support (1088) to I/P lower trim pad attaching bolt (1089).
17. Position wedge between RH I/P outer support (1088) and I/P lower trim pad (134).
18. Heater control vacuum harness (130) from vacuum/electric solenoid assembly (104).
19. Two screws retaining vacuum/electric solenoid assembly (104).
20. Vacuum/electric solenoid assembly (104) from heater core cover (1091).
21. Six screws (131) and two clips (1100) from heater core cover (1091).
22. Heater core cover (1091) and seal (1094) from temperature case (1090).
23. Heater core lower bracket retaining screw.
24. Heater core lower bracket.
25. LH retaining screw from heater core upper bracket.
26. Loosen RH retaining screw from heater core upper bracket.
27. Adjust heater core upper bracket to allow heater core (1097) removal.
28. Heater core inlet/outlet tubes from tube/case seal (1096).
29. Heater core (1097) and seal (1094) from temperature case (1090).

INSTALL OR CONNECT

Front Heater Core|Page 2338 > < Front Heater Core|Page 2336