Silhouette V6-191 3.1L VIN D TBI (1995)
INSTALL/CONNECT
CAUTION:
^
Use care when pressing retainer into hole in rod to ensure that cable is not kinked or damaged in any way.
^
To prevent possible interference, flexible components (hoses, wires, conduits, etc.) must not be routed within 50 mm (2") of moving parts unless
routing is positively controlled.
^
Wire, hoses, cables, or other obstructions must not be placed within 13 mm (1/2") of cable or rod at any point in their travel.
1. Reverse procedure to install.
NOTE: Check for complete throttle opening and closing by operating accelerator pedal. Also check for poor carpet fit under the accelerator pedal.
Throttle should operate freely without bind between full closed and wide open throttle.
2. Apply heavy bodied sealer around accelerator cable at engine compartment side of dash panel bulkhead.
