Silhouette V6-191 3.1L VIN D TBI (1995)
1. Clean all parts in power steering fluid, then thoroughly dry all parts.
2. Lubricate new drive shaft seal with power steering fluid, then install seal into pump housing using suitable seal installation tool or socket.
3. Install pump ring dowel pins into pump housing.
4. Install thrust plate, pump rotor and new shaft retaining ring onto drive shaft.
5. Install drive shaft subassembly into pump housing.
6. Install vanes into pump rotor.
7. Install pump ring onto dowel pins.
8. Lubricate new oil ring with power steering fluid, then install O-ring into end cover.
9. Lubricate outer edge of end cover with power steering fluid, then press end cover into pump housing.
10. Insert O-ring into groove in pump housing with ring opening near access hole in pump housing.
Disassembly
CAUTION: Prior to disassembly of the pump, remove filler cap and drain fluid. If broken components or foreign materials are found during
disassembly, then the hydraulic system should be disassembled, inspected, cleaned and flushed before service is complete.
Fig. 1 Exploded View Of TC Series Power Steering Pump
1. Clean exterior of pump with solvent, then clamp front hub of pump into a soft jaw vise.
