Silhouette V6-3.4L VIN E (1996)
9. Vacuum/electric solenoid assembly from heater core cover.
10. Heater core cover and seal from temperature case.
11. Heater core lower bracket.
12. LH retaining screw from heater core upper bracket. Loosen RH retaining screw from heater core upper bracket and adjust heater core upper
bracket to allow heater core removal.
13. Heater core inlet/outlet tubes from tube/case seal.
14. Heater core and seal from temperature case.
INSTALL OR CONNECT
1. Heater core inlet/outlet tubes into tube/case seal and heater core and seal into temperature case (adjusting heater core upper bracket).
2. LH retaining screw to heater core upper bracket - do not fully tighten.
3. Heater core lower bracket with retaining screw. Adjust positioning of heater core in temperature case to prevent any movement and tighten heater
core bracket retaining screws to 3 Nm (27 lb in).
4. Heater core cover and seal to temperature case with six screws and two clips and tighten heater core cover screws to 7 Nm (62 lb in).
5. Vacuum/electric solenoid assembly to heater core cover and tighten the two screws to 7 Nm (62 lb in).
6. Heater control vacuum harness to vacuum/electric solenoid assembly. Remove wedge from between RH I/P outer support and I/P lower trim pad.
7. RH I/P outer support-to-I/P lower trim pad attaching bolt and tighten to 10 Nm (89 lb in).
8. Two screws retaining I/P lower extension housing to I/P lower extension support brackets and tighten to 3 Nm (27 lb in).
9. I/P compartment into I/P and tighten screws to 3 Nm (27 lb in).
10. Floor (courtesy) lamp to RH I/P sound insulator panel while positioning panel into I/P.
11. RH I/P sound insulator panel screw, nut and push-in retainers. Tighten attaching screw to 3 Nm (27 lb in).
12. Heater inlet and outlet hoses to heater core and secure with clamps.
13. Refill engine coolant.
