Silhouette V6-3.4L VIN E (1996)
Engine Control Module: Service and Repair
Powertrain Control Module (PCM) Replacement/Programming
Caution: In order to prevent possible electrostatic discharge damage to the PCM, do not touch the connector pins or soldered components on the
circuit board.
Service of the PCM should normally consist of either replacement of the PCM or EEPROM programming. If the diagnostic procedures call for PCM
Replacement, check the PCM first to see if it is the correct part. If the PCM is faulty, remove it and install the new service PCM.
The new service PCM will not be programmed. You must program the new PCM. DTC P06O2 indicates the EEPROM is not programmed or has
malfunctioned.
Caution: In order to prevent possible electrostatic discharge damage to the PCM, do not touch the connector pins or soldered components on the
circuit board.
Caution: In order to prevent internal PCM damage, leave the ignition should OFF when installing or removing the PCM connectors and
disconnecting or reconnecting the power to the PCM (battery cable, PCM pigtail, PCM fuse, jumper cables, etc.).
Note: When replacing the production PCM with a service PCM (controller), it is important to transfer the broadcast code and production PCM
number to the service PCM label. Do not record on PCM cover. This will allow positive identification of PCM parts throughout the service life of
the vehicle.
Caution: In order to prevent internal PCM damage, leave the ignition should OFF when installing or removing the PCM connectors and
disconnecting or reconnecting the power to the PCM (battery cable, PCM pigtail, PCM fuse, jumper cables, etc.).
