Silhouette V6-3.4L VIN E (1996)
Ride Height Sensor: Adjustments
CAUTION: When repair or adjustment procedures require that vehicle be raised on a hoist, it is important that the rear axle assembly remains in
the normal trim height position at all times. When a frame contact hoist is used, two additional jack stands should be used to support the rear axle
or control arms in the normal trim height position.
Fig. 21 Adjusting Height Sensor
NOTE: The link should be properly attached to the sensor arm and track bar, when making this adjustment.
1. Loosen lock bolt that secures metal arm to height sensor plastic arm, then proceed as follows:
a. To raise vehicle trim height, move plastic arm upward and tighten lock bolt.
b. To lower vehicle trim height, move plastic arm down and tighten lock bolt.
2. If adjustment cannot be made, check for correct sensor, bent or damaged components.