Silhouette FWD V6-3.4L VIN E (2004)
Power Sliding Door Motor: Service and Repair
Motor Clutch Replacement - PSD (With RPO Code E59)
MOTOR CLUTCH REPLACEMENT - POWER SLIDING DOOR (WITH RPO E59)
REMOVAL PROCEDURE
1. Disconnect the negative battery cable.
2. Remove the left rear quarter lower trim panel
3. Open the left sliding door 1/3 of the way.
4. Support the bottom of the left sliding door.
5. Remove the center roller bracket pin. Separate the center roller bracket, body side, from the center roller bracket, door side.
6. Position the bottom of the sliding door out at the rear in order to provide access to the center roller bracket, body side.
7. Position the sliding door center roller bracket, body side, at the front of the center roller track.
8. Release the cable tension.
9. Lift the center roller bracket, body side, up and out from the front radius of the sliding door center track.
10. Detach the cable ends from the sliding door center roller bracket, body side.
11. Remove the sliding door center track cover.
