Silhouette FWD V6-3.4L VIN E (2004)
Fuel Door: Service and Repair
Fuel Filler Pocket Replacement
Fuel Filler Pocket Replacement
Tools Required
J 38778 Door Trim Pad Clip Remover
Removal Procedure
1. Open the fuel filler door.
2. Remove the fuel cap.
3. Using J 38778 remove the push in retainer securing the fuel filler pocket to the left rear inner fender liner.
4. Remove the screws from the fuel filler pocket.
5. Remove the fuel filler pocket from the vehicle.
6. Depress tabs on the fuel cap tether and remove from the fuel filler pocket.
Installation Procedure
1. Align the fuel filler pocket to the vehicle
Notice: Refer to Fastener Notice in Cautions and Notices.
2. Install the screws to the fuel filler pocket.
Tighten the screws to 10 N.m (89 lb in).
3. Install the push in retainer to the fuel filler pocket.
4. Install the fuel cap to the fuel filler pocket.
5. Close the fuel filler door.
