Silhouette FWD V6-3.4L VIN E (2004)
Splash Guard: Service and Repair
Splash Shield Replacement - Engine
Splash Shield Replacement - Engine
Tools Required
J 38778 Door Trim Pad and Garnish Clip Remover
Removal Procedure
1. Use J 38778 to remove the push-in retainers from the engine compartment side rail.
2. Use J 38778 to remove the push-in retainers from the front fender liner at the engine splash shield.
3. Remove the front wheel speed jumper harness from the left engine splash shield. Refer to Wheel Speed Sensor
Replacement (Front) in Antilock Brake System.
4. Remove the front wheel speed jumper harness from the right engine splash shield. Refer to Wheel Speed Sensor
Replacement (Front) in Antilock Brake System.
5. Disconnect the battery cable from the right engine splash shield. Refer to Battery Cable Replacement in Engine Electrical.
6. Remove the engine splash from the vehicle.
Installation Procedure
Important: The battery cable and the ABS harness must be installed to the engine splash shield prior to installation of the engine splash