Silhouette FWD V6-3.4L VIN E (2004)
3. Install the J 29113 onto the crankshaft.
4. Pull the crankshaft balancer into position.
5. Remove the J 29113 from the crankshaft balancer.
Notice: Refer to Fastener Notice in Service Precautions.
6. Install the crankshaft balancer washer and bolt.
Tighten the crankshaft balancer bolt to 103 Nm (76 ft. lbs.).
7. Use the utility stand in order to raise the frame/powertrain.
8. Install NEW frame right side bolts.
9. Install the right engine splash shield.
10. Install the right front tire and wheel.
11. Lower the vehicle.
12. Install the drive belt.