Silhouette FWD V6-3.4L VIN E (2004)
Oil Pressure Sensor: Service and Repair
Engine Oil Pressure Sensor and/or Switch Replacement
Removal Procedure
1. Remove the battery negative cable from the battery.
2. Raise and suitably support the vehicle. Refer to Vehicle Lifting.
3. Remove the electrical connector from the engine oil pressure sensor.
4. Remove the engine oil pressure switch.
Installation Procedure
Notice: Refer to Fastener Notice in Service Precautions.
1. Install the engine oil pressure switch.
Tighten the switch to 16 Nm (12 ft. lbs.).
2. Install the electrical connector to the engine oil pressure switch.
3. Lower the vehicle.
4. Install the battery negative cable to the battery.
