Silhouette FWD V6-3.4L VIN E (2004)
6. Open the push rod retainer clip (1) with a small flat bladed screwdriver.
7. Disconnect the push rod (2) from the retainer clip (1).
8. Align the third thread (1) on the push rod with the end of the retainer clip.
9. Close the push rod retainer clip.
10. Inspect the air flow during the following conditions to verify proper operation:
-
No significant air bleed from the vent outlet during Heater mode.
-
Suitable air flow from the vent outlet during Bi-level mode.
11. Open the push rod retainer clip with a small flat bladed screwdriver.
IMPORTANT:Perform the following if air bleed is felt from the vent outlet during Heater mode.
12. Disconnect the push rod from the retainer.
13. Position the push rod so that the tip of the push rod will appear longer by one thread.
14. Close the retainer clip and test again for air bleed.
