Silhouette FWD V6-3.4L VIN E (2004)
5. Carefully slide the new sealing washers onto the evaporator line until seated.
6. Install the TXV to the evaporator core.
7. Install the TXV mounting screws.
NOTE: Refer to Fastener Notice in Service Precautions.
Tighten
Tighten the screws to 3.2 N.m (28 lb in).
IMPORTANT:Align the evaporator temperature sensor wires with the opening in the upper HVAC module case. Improper alignment will pinch and/or
cut the sensor wires.
8. Install the evaporator core into the upper HVAC module case half.
9. Align and install the upper module case to the lower module case.
10. Install the lower HVAC module assembly retaining screws.
