Silhouette FWD V6-3.4L VIN E (2004)
2. Install the TXV to the evaporator core.
3. Install the TXV to evaporator bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings
Tighten
Tighten the bolts to.....3.2 N.m (28 lb in).
4. Remove the cap or tape from the evaporator inlet and outlet tubes.
5. Install the new sealing washers onto the evaporator inlet and outlet tubes.
6. Install the evaporator inlet tube to the evaporator outlet tube.
7. Install the evaporator outlet and inlet tubes to the TXV.
8. Install the evaporator outlet tube nut.
Tighten
Tighten the nut to.....16 N.m (12 lb ft).
9. Connect the vacuum hose to the brake booster.
10. Reposition the heater hoses.
11. Install the left wiper arm linkage.
12. Install the left wiper arm linkage nuts.
Tighten
Tighten the nuts to.....5 N.m (44 lb in).
13. Evacuate and recharge the A/C system.
14. Leak test the fittings of the component using J 39400-A.
