Silhouette FWD V6-3.4L VIN E (2004)
10. Remove the auxiliary TXV to evaporator core bolts.
11. Remove the auxiliary TXV from the evaporator core.
12. Cap or tape off the evaporator core lines.
13. Remove and discard the sealing washers.
INSTALLATION PROCEDURE
1. Remove the cap or tape from the evaporator lines.
2. Install the new sealing washers onto the evaporator lines.
3. Install the auxiliary TXV to the evaporator core.
4. Install the auxiliary TXV to the evaporator core mounting bolts.
NOTE: Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings
Tighten
Tighten the bolts to.....3.5 N.m (31 lb in).
5. Remove the cap or tape from the A/C lines.
6. Install the new sealing washers onto the A/C line.
7. Install the A/C lines to the auxiliary TXV.