Silhouette FWD V6-3.4L VIN E (2004)
INSTALLATION PROCEDURE
1. Install a new sealing washer onto the compressor end of the suction hose.
2. Install the suction hose.
3. Position the engine mount strut bracket flush with the upper radiator support.
4. Install the right hand engine mount strut bracket brace bolts to the upper radiator support.
NOTE: Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings
Tighten
Tighten the bolts to.....28 N.m (21 lb ft).
5. Tighten the right hand engine strut mount nuts, engine side.
Tighten
Tighten the bolts to.....48 N.m (35 lb ft).
6. Raise the vehicle.
7. Connect the compressor electrical connector.
8. Connect the engine harness electrical connector.
9. Remove the cap or tape from the compressor suction port.