Silhouette FWD V6-3.4L VIN E (2004)
5. Install the evaporator outlet tube bolt (1) at the compressor suction hose.
NOTE: Refer to Fastener Notice in Service Precautions.
See: Service Precautions/Vehicle Damage Warnings
Tighten
Tighten the bolt to......16 N.m (12 lb ft).
6. Connect the evaporator inlet tube to the evaporator outlet tube.
7. Remove the cap or tape from the TXV.
8. Connect the evaporator inlet and outlet tubes to the TXV.
9. Install the evaporator outlet tube nut at the TXV.
Tighten
Tighten the nut to.....16 N.m (12 lb ft).